Radial Engineering MC3 Studio Monitor Controller w/ Headphone Amplifier

TheMC3fromRadial Engineeringis a studio monitor controller that enables an engineer to quickly select between reference monitors, sub woofer or headphones and compare how the mix translates via various playback systems. The unit is 100% passive and delivers “straight wire” performance, eliminating any coloration and distortion that can be introduced via active electronics.

Several features make the unit stand out. The first is a switch that quickly sums the output to mono to check for AM radio compatibility. Secondly, the sub output can be switched to a 180 polarity reversal in the event help is needed to deal with room nodes in the mix position. Additionally, each output is equipped with a top-mount “set and forget” dial to fine tune outputs for the ideal balance.

Two 1/4″ headphone outputs with a volume control allow for sharing mix monitoring. To facilitate the trend towards portable device listening, a separate 1/8″ headphone output takes ear buds for checking mix levels. A separate Dim switch is also adjustable to enable the engineer to temporarily drop the playback level without affecting the mix level settings. The unit may be configured for either balanced or unbalanced setups.

Passive studio monitor switcher with headphone amplifierControl two sets of monitors and a sub wooferStraight wire resistive audio circuit ensures distortion-free signal transfer1/4″ TRS input and output connectorsMono sum for AM radio compatibility and phase checkIndividual “Set and Forget” controls to fine tune levels on the top panelDual output headphone jacks allow for sharing a mix with the producer1/8″ (3.5 mm) stereo mini headphone output for use with ear-budsDim switch reduces the playback level in the studio without affecting the monitor playback settingsSub switch allows for activating the sub woofer separately180 reverse switch used to reverse the polarity of the sub woofer to counter the effect of room nodesBalanced or unbalanced operationDouble sided military grade circuit board with full ground plane to reduce radio frequency interferenceExtra durable switches with metal outer casing are rated at over 20,000 cycles for added durabilityI-BEAM reinforced enclosure makes it impossible to torque the PC board and eliminates cold solder jointsBookend design creates a protective zone around the switches and potentiometers to keep them out of harm’s way